Here is an example task using the series plugin: series: This allows more refined configuration per entry field selection. Transmission plugin will also utilize options from entry fields. To use all default values use this config form: transmission: yes Will set the torrent's position in the queue to the specified number, where 0 is the top of the queue Will 'skip' file patterns if main_file_only is not enabled OR the main_file_only requirement isn't met in the torrent. Will include file patterns if they have been excluded by 'main_file_only'. If enabled, file patterns matching the main file will be renamed according to 'content_filename' This can be used to rename the main file inside the torrent. If yes, in addition to the main file, files with subtitle extensions will be downloaded (.srt. When the timeout is set greater than 0 and a magnet URI is added, the task will wait up to the timeout (seconds) for the torrent to magnetize before continuing (Default: 0) Expects a number between 0 and 1 (ie 0.85 to change to 85%). Sets the threshold value for main_file_only. If yes, all files but the main file inside the torrent (> 'main_file_ratio' of total) will be set to 'skip' The ratio to stop seeding at (-1 means infinite) If this options is specified for already downloaded torrent then transmission will move downloaded torrent data to new location. (default: add)ĭestination for downloaded file(s). The action that should be performed on this torrent. Where transmission is listening (default: localhost) If you can authenticate from the web client, you should have no problems authenticating with your flexget configuration file as follows: transmission: Test the connection by clicking on "Open web client" button. If "Only allow these IP addresses" is checked, be sure to have your IP included. Check "Allow remote access" and set your username and password. In this case: Open transmission-gtk, go to Edit > Preferences, and navigate to the Remote tab. If you are running Ubuntu, or most any modern distribution, chances are great that you have transmission-gtk instead of transmission-daemon. The settings below will permit clients connecting from localhost and .x, assuming they also provide the correct credentials, it will also deny all other IP ranges. First stop transmissiond, edit settings.json and enter a password in clear text it will be overwritten with its hash once transmissiond is started again.Īlso make sure that rpc-whitelist isn't preventing FlexGet from connecting to localhost or whatever IP address it's using. The username and password can be set from the GUI, but if you're using the headless version you must change it in /home//.config/transmission-daemon/settings.json. Install a specific version: pip install transmission-rpc=3.4.1 transmission-rpc 4.0.0 or newer requires python 3.8 or newer. Transmission version 4.0.0 or newer requires transmission-rpc version 3.4.1 or newer. Transmission version 3.0 or older requires transmission-rpc version between 3.2.6 to 3.4.1. Newer versions of flexget now depend on transmission-rpc 3.2.6 or higher. You may be required to upgrade transmission-rpc after upgrading transmission, for that just add -upgrade to the previous command. To install it, run: pip install transmission-rpc This plugin requires the transmission-rpc library. Mainly used to add new torrents to transmission, but can also be used to pause/resume/remove torrents already loaded in transmission. Manages torrents within the Transmission bittorrent client.
0 Comments
Leave a Reply. |